Over-Current Protection (OCP) is a feature built in WattBox units to protect your gear and installation from instances of excessive current. Over-Current Protection in the 800 Series WattBox protects from two types of excessive current:
- Instantaneous Over-Current: A large in-rush of current at one time, typically experienced when powering up amplifiers.
- Constant Over-Current: Continuous current over the unit’s UL rating of 12A.
When Over-Current Protection is triggered, ‘Device Activities’ in OvrC will differentiate between the two.
Ways to Troubleshoot
For Instantaneous OCP:
If a single outlet is off:
- Is the product an amplifier that may have a high in-rush current? If so, remove the amplifier from the IP-controlled WattBox to a surge-only WattBox.
If 3 consecutive outlet groups turn off (1 -3, 4- 6, etc.)
- Set unique power-on delays for the devices with high in-rush current.
- Try rearranging the devices such that they are no longer on 3 consecutive outlets within a group.
- Are these outlets powering amplifiers/AVRs? If so, we recommend not using an IP-controlled WattBox, instead, use a surge protection-only WattBox.
For Constant OCP:
- Never daisy chain power strips off WattBox PDUs. The WattBox 800 Series PDUs are UL rated for 12A. Any outlet that sees a current draw higher than 12A will go into protection mode to prevent permanent damage to the PDU and/or to the wiring on-premise.
For additional information, please contact Tech Support at 1-888-400-4072 or by email at [email protected]
Leave A Reply!